0

Your Cart is Empty

I.V2 Dual Mono Power Amplifier

Take advantage of the increased dynamic capability of high resolution recordings with the Legacy i·V2 dual mono amplifier. You will enjoy a lower noise floor in your recordings, stronger crests, and increased dynamic resolution.

Amplifier comes in versions of up to 8 channels, selectable through the drop down provided. Perfect for any home theater application!

  • Free Shipping on Legacy Products:
    No coupon code needed!

    Selling Restrictions:

    We can only sell Legacy Products to USA addresses. If you are outside the USA, please contact Legacy Audio for a dealer in your country.

    Permission is needed to purchase from Morrow Audio:
    Please contact us before your purchase. We are not allowed to sell to you if you have a dealer in your area.

    Featuring state of the art ICEedge® technology, the elegant i·V2 amplifier approaches 80% efficiency while delivering over 600 watts per channel into 8 ohms, both channels driven. Such exceptional power is the product of very high current (i) and voltage (V) output capabilities providing stability into low impedances with a peak output current capability of 38A. 

     i·V 2 Features:

    • Short circuit protection
    • Thermal protection
    • Triggered On/Off
    • Standby switch
    • Front panel status indicator

    Say goodbye to excessive heat and transformer hum. The crystal-clear sound is virtually noise-free and reliability is assured- after all, it’s a Legacy.

    High amplifier power assures the proper snap in transients and prevents clipping that can damage high frequency drivers. Higher power means dense musical arrangements will avoid the smearing, strain and the inevitable distortion as complex passages reach higher levels.

    Recommended Cables: Morrow Audio SP4 or higher level speaker cables cables are excellent for this product.

    Our Buyers Guide can also help you choose the perfect cables for your system.

  • The binding post on the amplifier accepts our Standard Spade, Banana and bare wire (nude) cable terminations.

  • Equipment needs break-in. the sound will change slightly during this period. You can expect around 100 hours for complete break-in. Simply play the amplifier at normal listening levels to break it in.
  • Product Manual Download (535 KB)
    Power Rating: 1000 watts per channel x 2 @ 4 ohms, all channels driven 610 watts per channel x 2 @ 8 ohms, all channels driven
    Peak Power: 1.2 kW peak power from any channel @ 4 Ohm/1kHz with less than 1% distortion
    Over Current Protection: Breaker reset for excessive sustained current
    Inputs: Fully balanced XLR, single-end RCA
    Outputs: Gold plated safety approved five-way binding posts
    Damping factor: 750 average, 20Hz to 1kHz
    Voltage Gain: 25.8 dB
    Dynamic Range: 127dB, A- weighted
    Voltage/Current: 98 Vp / 38Ap
    Input Sensitivity: 5.0Vp @ 1200W/4 Ohm
    Input Impedance: 38 kOhm for both pin 2+ and pin 3-
    Channel Separation: 120 dB at 1kHz
    Unit Shipping Weight: 30 lbs
    Unit Dimensions: 17.5" W x 15.6" D x 5.8" H
    Notes: Highest power output can be obtained using a single 230V, 20A line or dual 120V, 20A lines. A conventional single AC cord is also provided.

  • There are no returns for Legacy products. See Policy